---
title: "UC512 LoRaWAN Solenoid Valve Controller"
canonical: "https://help.scopious.co.nz/space/KB/713064536/UC512+LoRaWAN+Solenoid+Valve+Controller"
format: markdown
---
![image]()

Milesight UC512 LoRaWan IoT Controller with Latching Solenoids and Pulse Meter support

---

[Store Link](https://www.gowifi.co.nz/milesight-iot/uc512-di-915m.html)

## Supported Commands (12)

| **Name** | **Description** | **Version Requirements** |
| --- | --- | --- |
| **Set Command Response Time** | Set the interval at which the device will check for commands — a lower interval results in lower command execution latency, at the cost of higher battery consumption. |  |
| **Toggle Data Retransmission** | Enable/Disable data retransmission on network outtage |  |
| **Set Reporting Interval** | Change the rate at which the device uplinks data |  |
| **Set Collection Interval** | The interval for collecting data when there is an alarm command. This interval must not be more than the reporting interval. |  |
| **Reset GPIO Counter** | Reset the counter for a GPIO pin |  |
| **Update Valve Status - Pulse Limit** | Open or close a device valve until a specified number of pulses have gone through. |  |
| **Update Valve Status - Time Period** | Open or close a device valve for a specific amount of time |  |
| **Update Valve Status** | Immediatly open or close a device valve |  |
| **Set Data Retransmission Delay** | Set the delay after a network reconnect to resend data. For this setting to take effect, both data storage and data retransmission must be enabled. |  |
| **Reboot** | Reboot the device |  |
| **Set Counter Initial Value** | Set pulse counter initial value |  |
| **Set Pulse Filter** | Filter the pulse counting values below this rate. This only works when the GPIO working mode is 'Water Volume Counter'. Applies to both
GPIO interfaces. |  |