---
title: "AT101 Battery Powered GNSS & Wifi Tracker"
canonical: "https://help.scopious.co.nz/space/KB/713031723/AT101+Battery+Powered+GNSS+%26+Wifi+Tracker"
format: markdown
---
![image]()

Milesight AT101 LoRaWAN IoT Asset Tracker

---

[Store Link](https://www.gowifi.co.nz/milesight-iot/at101-915m.html)

## Supported Commands (19)

| **Name** | **Description** | **Version Requirements** |
| --- | --- | --- |
| **Set Positioning Strategy** | Set the positioning strategy of the device. |  |
| **Toggle Data Retransmission** | Enable/Disable data retransmission on network outtage |  |
| **Set Time Zone** | Set the time zone on the device |  |
| **Set Wi-Fi Scan Config** | Set the BSSID count and positioning timeout when the device uses the Wi-Fi Scan strategy. |  |
| **Set Reporting Schedule** | Set the times at which the device will report its location when in timing mode |  |
| **Set GNSS Positioning Timeout** | Maximum time to attempt GNSS positioning. |  |
| **Set Reporting Interval** | Change the rate at which the device reports a position depending on the mode. |  |
| **Toggle Bluetooth** | Enable/disable Bluetooth connectivity. |  |
| **Set Geofence Coordinates** | Set the latitude and longitude for the centre of the geofence. Enter the coordinates scaled by 1,000,000 to avoid decimal values. |  |
| **Set Duration of Motion or Stationary** | Set the duration that the device must be in motion or stationary for the state to change. |  |
| **Set Geofence Radius** | Set the radius of the geofence circle around the central coordinates. |  |
| **Toggle Data Storage** | Enable or disable data storage. When the device disconnects from the network, if enabled, it will store its uplinks and resend once connected. |  |
| **Set Data Retransmission Delay** | Set the delay after a network reconnect to resend data. For this setting to take effect, both data storage and data retransmission must be enabled. |  |
| **Set Geofence Config** | Set the configuration for geofence alerting. When enabled and set, the device will send an alarm packet while outside of the configured area. |  |
| **Set Initial Orientation** | Set the initial orientation for the device if the tamper alarm is enabled. When the device is rotated from this position, an alarm packet is sent. |  |
| **Reboot** | Reboot the device |  |
| **Set Work Mode** | Change the work mode of the device. |  |
| **Toggle Tamper Alarm** | Enable/disable the tamper alarm. When the device is tilted from its initial position, the alarm will trigger. |  |
| **Set Reporting Interval During Motion** | Set the interval at which the device will report its location while it is in motion. |  |