---
title: "UC502-v3 Multi Interface LoRaWAN Controller"
canonical: "https://help.scopious.co.nz/space/KB/711852083/UC502-v3%20Multi%20Interface%20LoRaWAN%20Controller"
format: markdown
---
Supported Commands (9) Name Description Version Requirements Toggle Data Retransmission Enable/Disable data retransmission on network outtage Reboot Reboot the device Hardware: 3.0+, Firmware: 1.5+ Hardware: 3.0+, Firmware: 1.6+ Set Reporting Interval Change the rate at which the device uplinks data Set Data Retransmission Delay Set the delay after a network reconnect to resend data. For this setting to take effect, both data storage and data retransmission must be enabled. Toggle GPIO on/off Turn on or off a GPIO pin Change I/O Level Change the power level of a specific GPIO pin Toggle Analog Input Turn off or on the analog inputs for the device Set Collection Interval The interval for collecting data when there is an alarm command. This interval must not be more than the reporting interval. Toggle SDI-12 Enable / Disable SDI-12